PDF EN - Tornos

More documents

Recommendations

Info

Technical Technical specifications maximum bore 8 mm / outer dia. 16 mm for F13, maximum bore 13 mm equivalent to special F20 (Deco 13) requires a special clamp to be made-to-measure. Principe By comparison with traditional clamping, the tapered sleeve is transformed into a guide system and a tapered push piece is added inside the sleeve. During clamping, the tube pushes onto the guide sleeve and actuates the tapered push piece on the cone of the clamp. Compatibility DECO 10a / 10e, DECO 13a / 13e Availability This device is available on demand. Comments Special clamps are made-to-measure according to the parts to be produced. 20 decomagazine 02 / 09
THE KEY TO YOUR SUCCESS! www.wibemo.ch OUTILLAGE DE PRÉCISION
Page 1 and 2: decomagazine THINK PARTS THINK TORN
Page 3 and 4: 10 14 37 47 High-tech at Stryker Sp
Page 5 and 6: Editorial SITUATION UNDER CONTROL W
Page 7 and 8: Options Machining of PEEK workpiece
Page 9 and 10: ROTATING SPINDLE DEVICE WITH INCLIN
Page 11 and 12: The two tailstock spindles, each mo
Page 13 and 14: Before Motorex Ortho NF-X was allow
Page 15 and 16: from specialist manufacturers. Not
Page 17 and 18: Micro 8 GR 600 TWIN GR 600 TWIN GR
Page 19: Technical DEVICE FOR CLAMPING FROM
Page 23 and 24: to be shortened, while offering the
Page 25 and 26: THE PERFECT SOLUTION FOR TOUGH TIME
Page 27 and 28: a bonus for the service. Overall, w
Page 29 and 30: ing our expertise. The competition
Page 31 and 32: long production runs of relatively
Page 33 and 34: machines with additional equipment
Page 35 and 36: dm : I have a good understanding of
Page 37 and 38: Dossier WORLD CLASS SUPPLIER CLOSE
Page 39 and 40: Ms Cigdem Calvez, Plant Manager and
Page 41 and 42: 02 / 09 decomagazine 41
Page 43 and 44: Technical WHEN 3 % WILL MAKE YOU OV
Page 45 and 46: Thread whirling cutters or inserts
Page 47 and 48: Interview AT THE FOREFRONT OF MEDIC
Page 49 and 50: nomic landscape is a formula for de
Page 51 and 52: Tricks and tips PRE-SETTING OF TOOL
Page 53 and 54: For pre-setting the geometry of a t
Page 55 and 56: Common benefits of monobloc tool ho
Page 57 and 58: Interview PROGRAMMING STANDARDIZATI
Page 59 and 60: continuing to programme the machine
Page 61 and 62: 3. Bimu specialist application : Us
Page 63 and 64: The present A STRONGER COMMUNITY Po
Page 65 and 66: Vocational education students expla
Page 67: www.bimu.ch Tecko TTS Twin system

PDF EN - Tornos

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?