2011 Filter and Fluid Application Guide PEWJ0074-04

Cat Machines
Track Loaders
1039980
Lubricants - Undercarriage
The product(s) listed below are the Caterpillar preferred product. For additional options, please consult the Caterpillar Machine
Fluids Recommendations (SEBU6250).
Oil Type and Category
Oil Viscosities Min °C Max °C Min °F Max °F
Equalizer Bar End and Pin Joint
Cat GO SAE 80W-90 -20 40 -4 104
Cat GO SAE 85W-140 -10 50 14 122
Cat Synthetic GO SAE 75W-140 -30 45 -22 113
Track Roller Frame Recoil Spring and Pivot Shaft Bearings
Cat TDTO Cold SAE 0W-20 -40 0 -40 32
Weather
Cat TDTO SAE 10W -30 0 -22 32
Cat TDTO SAE 30 -20 25 -4 77
Cat TDTO SAE 50 0 50 32 122
Cat TDTO-TMS TDTO-TMS -25 25 -13 77
Track Idlers and Track Rollers
Cat DEO-ULS SYN SAE 5W-40 -35 40 -31 104
1039987
Greases
Application Point: Equalizer Bar Pin, Recoil Piston, Track Adjustment
Typical Applications Load Factor Ambient Temperature
Ambient Tempera-
NLGI Grade Recommended
(Load and Speed)
Range (°C) Min, ture Range (°F) Min,
Grease Type
Max
Max
High
Continuous excavating
-30, 50 -22, 122 2 Ultra 5Moly Grease
and loading
from bank. Land
clearing.
High -35, 40 -31, 104 1 Ultra 5Moly Grease
High -40, 35 -40, 95 0 Ultra 5Moly Grease
Medium
Low
1039994
Filters
Bank or stockpile
loading with idling
periods. Load and
carry.
Large amounts of
idling in any application.
-20, 40 -4, 104 2 Advanced 3Moly
Grease
-30, 40 -22, 104 2 Multipurpose
Grease
The “Part Number” column represents the “As Shipped” filters. As Shipped filters are the minimum recommendations for filter
efficiency for that particular system. Higher efficiency filters may be used, but to prevent damage do not use lower efficiency
options.
2291920
931B
Filter needs differ between machine arrangements. Filters for engines are listed separately from machine arrangements. Engine
filters are designated by “(Engine)” following the model. Please review both machine and engine arrangements carefully before
finalizing filter selection.
(Continued)
512