2011 Filter and Fluid Application Guide PEWJ0074-04

Lubricants
Cat ® HYDO Advanced 30 (Continued)
2313211
Cat HYDO Advanced 30 Typical Characteristics {A}
Characteristics HYDO Advanced 30 HYDO Advanced 30 Advantages
SAE Viscosity Grade 30 Better wear protection, wider operating
temperature range
Viscosity “ “
cSt @ 40°C (ASTM D445) 90 “ “
cSt @ 100°C (ASTM D445) 10.6 “ “
Viscosity Index (ASTM D2270) 100 “ “
Viscosity after Shear (cST, during use) {B} 10.6 “ “
4 Ball (40kg/30min/600rpm/93°C ASTM 0.30 mm “ “
D4172)
Pour Point, °C (ASTM D97) -24 “ “
Brookfeld Viscosity @ -20°C (ASTM 13,600 “ “
D2983) mPaS
Zinc, % wt. (ASTM D495) typical 0.090 “ “
Copper Strip Corrosion (3 hr, ASTM D130) 1A @ 150°C
Corrosion protection
{C}
Rust Protection (ASTM D665B) Pass “ “
Oxidation stability, hours (ASTM D943) >5,000 Longer drain interval; lower owning and
operating costs
Long Drain Interval, confirmed by field Yes “ “
testing
Filterability, Wet, E DIN ISO 13357-1 Pass Reduced filter plugging; improves contamination
control due to better filtration
Foam Test {D} Reduces foaming
Seq. 1 ml. (ASTM D892) 0/0 “ “
Seq. 3 ml. (ASTM D892) 0/0 “ “
Seq. 3 ml. (ASTM D892) 0/0 “ “
Cleanliness
No interference with optical particle Accurate contamination control
counters
Ability to keep water in emulsion Yes Sludge control and water damage prevention
{A} The values shown are typical values and should not be used as quality control parameters to either accept or reject product.
Specifications are subject to change without notice.
{B} Oils that contain viscosity modifier additives will become thinner during use in this machine. This will reduce protection
level.
{C} 1A is better than 1B, 1A at 150º C is better than 1A at 100º C.
{D} New oil, as received, with 0.1% water by volume added.
Fluid Information and Part Numbers
Metric Volume (L)
18 319-5920
20 319-5921
200 319-5922
Part Number
Metric Volume (L)
208 319-5923
Bulk 319-5919
Part Number
755