simatic s7-400 - Teknika Otomasyon
simatic s7-400 - Teknika Otomasyon
simatic s7-400 - Teknika Otomasyon
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
© Siemens AG 2008<br />
SIMATIC S7-<strong>400</strong><br />
Modules for SIMATIC S7-<strong>400</strong>F/FH<br />
SIPLUS isolating module<br />
■ Overview<br />
SIPLUS S7-300 isolation module<br />
Order No.<br />
6AG1 195-7KF00-2XA0<br />
Order No. based on<br />
6ES7 195-7KF00-0XA0<br />
Ambient temperature range - 25 ... + 60 °C, condensation<br />
permitted<br />
Environmental conditions Suited for exceptional medial<br />
exposure (e.g. by chlorine sulfur<br />
atmosphere).<br />
Conforms with standard for Yes<br />
electronic equipment used on<br />
rolling stock (EN 50155,<br />
temperature T1, category 1).<br />
Technical data<br />
The technical data are identical with<br />
those of the based-on modules.<br />
Information about safety class and safety category see isolating<br />
module, page 5/128.<br />
5<br />
• Permits combined operation of fail-safe signal modules in<br />
safety mode and standard S7-300 modules in the same<br />
ET 200M system.<br />
• Design of PROFIBUS DP lines using copper bus cables. It is<br />
not necessary to use fiber-optic cables.<br />
• Every IM 153-x can be used<br />
The isolation module is not required if safety class SIL 2 is to be<br />
achieved.<br />
■ Ordering data<br />
Isolating module<br />
(medial exposure)<br />
for simultaneous operation of failsafe<br />
and standard modules in an<br />
ET 200M<br />
Accessories<br />
Order No.<br />
6AG1 195-7KF00-2XA0<br />
see Isolation module,<br />
page 5/128<br />
Failsafe input/output modules<br />
■ Overview<br />
• Failsafe input/output modules for use with the SIMATIC<br />
S7-<strong>400</strong>F/FH<br />
• With integrated safety functions<br />
• Can only be plugged into the ET 200M<br />
• Achievable safety classes in safety operation: SIL 2, SIL 3 to<br />
IEC 61508, AK 4, AK 6 to DIN V 19250, Category 3, 4 to<br />
EN 954-1<br />
• Use in standard mode with high diagnostics requirements<br />
• Also suitable for redundant operation<br />
For further information see section 4, page 111.<br />
Siemens ST 70 · 2009<br />
5/129