Owner's Manual EN Page 2 The above warning is located on the top ...

Panel Operation
ROUTING
Input routing
You can select either analog or digital input signals. Th<strong>is</strong> selection
links to the word clock master setting. You can also
route the left channel of an input signal received at the [IN-
PUT A] or [DIGITAL IN] connector to both Input channels
A and B.
Option
ANA A/B
ANA A/A
DIG L/R
DIG L/L
HINT
Input Signal Selection
A signal at the [INPUT A]
connector <strong>is</strong> routed to
channel A, and a signal at
the [INPUT B] connector
to channel B.
A signal at the [INPUT A]
connector <strong>is</strong> routed to
channels A and B.
A left channel signal <strong>is</strong>
routed to channel A, and
a right channel signal to
channel B.
A left channel signal <strong>is</strong>
routed to channels A and
B.
Word Clock
Master
Internal clock:
96kHz
Incoming AES/
EBU signal
You can check the word clock status on the Utility d<strong>is</strong>play. See
page 37.
1. Press the [ROUTING] key to select the
Routing d<strong>is</strong>play.
INPUT SELECT
SOURCE = ANA A/B
2. Press the [▲INC]/[▼DEC] keys to select an
input signal source.
INPUT SELECT
SOURCE = ANA A/A
Output routing
You can route Input channel A, B, and SUM signals to the
Crossover input.
<strong>The</strong> following three channels are available:
• IN A
• IN SUM
• IN B
1. Press the [ROUTING] key to select the
Routing d<strong>is</strong>play.
OUT 2
SOURCE = IN A
2. Press the [SEL] key for the target Output
channel.
<strong>The</strong> [SEL] key LED for the selected channel lights up.
<strong>The</strong> [SEL] key LED for each channel that shares the
same component flashes. <strong>The</strong> selected channel name appears
on the d<strong>is</strong>play.
OUT 4
SOURCE = IN A
3. Press the [▲INC]/[▼DEC] keys to select an
input source to be routed to the Crossover.
OUT 4
SOURCE = IN SUM
Foreword
Introduction
to the SP2060
<strong>The</strong> Controls
and Connectors
Network Settings Panel Operation
NOTE
Signals are muted while they are switched between analog and
digital to avoid no<strong>is</strong>e.
References
SP2060 Owner’s <strong>Manual</strong> 27