Hydro-Gear ZT-5400 transaxles manual - BIBUS France
Hydro-Gear ZT-5400 transaxles manual - BIBUS France
Hydro-Gear ZT-5400 transaxles manual - BIBUS France
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FAN AND PULLEY<br />
Refer to Figure 8<br />
1. Remove the locknut (183) and the washer<br />
(182).<br />
2. Remove the fan (181) and the washer<br />
(184).<br />
3. Remove the pulley assembly (180).<br />
Assembly<br />
1. Reassemble all parts in the reverse order<br />
of disassembly.<br />
2. When tightening the lock nut (183), refer to<br />
the table on page 15 for the required torque<br />
values.<br />
183<br />
182<br />
AXLE HUB ASSEMBLY<br />
Refer to Figure 8<br />
1. Remove the axle cap and discard (114).<br />
2. Remove the cotter pin and discard (116).<br />
3. Remove the castle nut (113).<br />
4. Remove the taper hub assembly (111) and<br />
discard.<br />
NOTE: A new hub will have to be ordered<br />
to replace the discarded hub.<br />
5. Remove the axle cover (115).<br />
6. Remove the axle shaft key (110).<br />
Inspection<br />
1. Check all components for excessive wear<br />
or damage. Replace if necessary.<br />
Assembly<br />
181<br />
1. Reassemble all parts in the reverse order<br />
of disassembly.<br />
184<br />
180<br />
2. When tightening the castle nut (113)*, refer<br />
to the table on page 15 for the required<br />
torque values.<br />
NOTE: As a general rule, use the low end of the<br />
torque specification . Once at the specified<br />
torque, rotate castle nut clockwise<br />
to align with nearest cotter pin hole.<br />
110<br />
*SEE PAGE 36 FOR ALTERNATE<br />
TORQUE METHOD.<br />
115<br />
111<br />
113<br />
114<br />
Figure 8, Fan and Hub<br />
<strong>ZT</strong>-<strong>5400</strong> Powertrain 17<br />
116