Hydro-Gear ZT-5400 transaxles manual - BIBUS France

More documents

Recommendations

Info

CONTROL ARM ASSEMBLY Refer to Figure 10 Disassembly 1. Remove all items previously discussed in their recommended order. 2. Remove the Torx head screw (56) and discard. 3. Remove the nut (57) and the washer (55). 4. Remove the control arm (54). 5. Remove the plastic washer (53) and the stud (52). 6. Remove the stop plate (65). Assembly 1. Reassemble all parts in the reverse order of disassembly. 2. When tightening the fasteners, refer to the table on page 15 for the required torque values. 3. Install new Torx head screw (56) and lip seal (51) from seal kit. NOTE: As a general rule, use the low end of the torque specification on fasteners when reassembling the unit. NOTE: Only remove the lip seal (51) and stop plate (65) if damaged or worn, or if doing a complete disassembly. Mark the orientation of the stop plate before removal. Inspection 1. Inspect all parts for excessive wear or damage. Replace if necessary. 51 65 66 67 52 53 54 55 57 56 Figure 10, Control Arm ZT-5400 Powertrain 19
FILTER AND FILTER COVER Refer to Figure 11 Disassembly 1. Remove the filter cover (152). 2. Remove the O-ring (151) from the cover (152) and discard. 3. Remove the filter (150) and discard. Inspection 1. Inspect all parts for wear or damage. Replace as necessary. Assembly 1. Install the new filter (150). 2. Install the new O-ring (151) onto the cover (152). 3. Install the filter cover (152). Refer to torque chart on page 15. 2. Check for old filter grommet stuck on the filter tube. Remove if present. 152 151 150 Figure 11, Filter and Filter Cover 20 ZT-5400 Powertrain
Page 1: ZT-5400 Powertrain Service and Repa
Page 4 and 5: FOREWORD Headquartered in Sullivan,
Page 6 and 7: DESCRIPTION AND OPERATION (CONTINUE
Page 8 and 9: EXTERNAL FEATURES ZT-5400 POWERTRAI
Page 10 and 11: SAFETY This symbol points out impor
Page 12 and 13: SERVICE AND MAINTENANCE NOTE: Any s
Page 14 and 15: PURGING PROCEDURES Due to the effec
Page 16 and 17: 2-SPEED OPTION SETTING WARNING POTE
Page 18 and 19: TOOLS REQUIRED TOOLS Miscellaneous
Page 20 and 21: FAN AND PULLEY Refer to Figure 8 1.
Page 24 and 25: BRAKE ASSEMBLY Refer to Figure 12 D
Page 26 and 27: BYPASS ACTUATOR Refer to Figure 14
Page 28 and 29: AXLE SHAFT AND PLANETARY GEAR SET R
Page 30 and 31: INPUT SHAFT Refer to Figure 19 Disa
Page 32 and 33: CENTER SECTION Refer to Figure 22 D
Page 34 and 35: MOTOR CYLINDER BLOCK, OPTIONAL 2-SP
Page 36 and 37: ASSEMBLY AFTER A COMPLETE TEARDOWN
Page 38 and 39: SIDE HOUSING - SCREW TIGHTENING SEQ
Page 40 and 41: ZT-5400 Powertrain 37
Page 42 and 43: ZT-5400 POWERTRAIN TRANSAXLE PARTS
Page 44 and 45: Integrated Zero-Turn Transaxle: The
Page 46: NOTES ZT-5400 Powertrain 43

Hydro-Gear ZT-5400 transaxles manual - BIBUS France

Create successful ePaper yourself

Delete template?

Save as template?