AP2257 - Draft A1 - Machined Part Modelling for CATIA V5
AP2257 - Draft A1 - Machined Part Modelling for CATIA V5
AP2257 - Draft A1 - Machined Part Modelling for CATIA V5
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AIRBUS<br />
<strong>Machined</strong> <strong>Part</strong> <strong>Modelling</strong> <strong>for</strong> <strong>CATIA</strong> <strong>V5</strong><br />
<strong>AP2257</strong><br />
L1 = Inner profile line<br />
L6<br />
α<br />
Z plane<br />
P1<br />
Remark:<br />
In cases where angle α of surface has a high variation, construct two<br />
sections at the limits of the pocket to be processed and take plane Z<br />
passing via the highest point.<br />
This is valid <strong>for</strong> an open or a closed angle.<br />
- Creation of sloped closed pocket solid without fillets<br />
• Use the same methodology as in the paragraph 4.1.2, in the ‘Creation of sloped<br />
closed pocket solid’ scenario<br />
Use to define the slot feature (Cm) (see paragraph 4.1.2) as guide curve and<br />
the sketch (Sk1) as profile<br />
- Fillet creation with a ‘multi-body’ methodology<br />
Issue:<strong>Draft</strong> <strong>A1</strong> Date: 13 February 2002 Page 37 of 46
Change language