powec as - Armspower.com

powec as
Product description communication
Dok.nr.:UK\PD\ZU\PowCom
Rev.: F
program - PowCom Page 16 of 27
Prepared: Arild Sagebø Date: 08.03.2000
Number of batteries
Sets the number of branches on the battery that are equipped with symmetry
measuring.
Boost time
Sets the duration of boost charging.
Boost interval
Sets the number of weeks between each boost.
Boost factor
Used to set the duration of boost after mains failure. See T1 LIMIT and T2
LIMIT.
T1 limit
When the voltage reaches below this limit, the system starts counting time.
When the voltage reaches over this limit again, the counting stops. The counted
time is used in a function with the boost factor when the voltage reaches over
T2 LIMIT.
T2 limit
When the system reaches over this limit the boost will start. The duration will
be the time from T1 LIMIT multiplied with the boost factor.
Over voltage shutdown
If the voltage reaches over this limit, the rectifier which delivers the highest
current will be switched off
High load
Entered in percent of the maximum power from the system. If the load current
get higher this limit, the system will give alarm to signal that there may not be
enough capacity to charge the battery.
Test time
Sets the time of day (0-23) when automatic test should start. E.g. 4 - the test
starts at 04.00.
Automatic test
Sets how many times each year automatic test shall be performed.
Battery type
Sets the type of battery which connected. Indicates how many blocks each
branch is divided into for symmetry measurements