Ascent 450 BL Park Glider PNP - E-flite
Ascent 450 BL Park Glider PNP - E-flite
Ascent 450 BL Park Glider PNP - E-flite
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8. Step back and view the airframe from roughly 8-10<br />
feet (2-3 meters) to check the alignment of the stabilizer<br />
to the wing. If they are not parallel to each other, lightly<br />
sand the fuselage where the stabilizer mounts to correct<br />
the alignment.<br />
Required Parts<br />
Fuselage<br />
Skid<br />
Fin/Rudder Installation<br />
Required Tools and Adhesives<br />
Felt-tipped pen<br />
Painter's tape<br />
Mixing cup<br />
Hobby knife<br />
Sandpaper<br />
Paper towels<br />
<br />
Fin/rudder<br />
6-minute epoxy<br />
Square<br />
Mixing stick<br />
Medium CA<br />
Rubbing alcohol<br />
1. Check the fit of the fin to the fuselage. It should slide<br />
into the fuselage so the hinge line of the fin/rudder<br />
aligned with the hinge line from the stabilizer/elevator.<br />
<br />
9. Use 6-minute epoxy to glue the stabilizer to the<br />
fuselage. Use painter's tape to keep the stabilizer tight<br />
against the fuselage until the epoxy fully cures. You may<br />
use rubbing alcohol and paper towels to clean up any<br />
epoxy that has squeezed out during assembly.<br />
E-<strong>flite</strong> <strong>Ascent</strong> <strong>PNP</strong> Assembly Manual<br />
11