Ascent 450 BL Park Glider PNP - E-flite

More documents

Recommendations

Info

8. Use 6-minute epoxy to glue the fin to the fuselage. 10. Use a felt-tipped pen to trace the outline of the of the skid on the bottom of the stabilizer. 9. Use painter's tape to keep the fin in position and square to the stabilizer while the epoxy cures. You may use rubbing alcohol and paper towels to clean up any squeeze out during this procedure. 11. Use a hobby knife with a new #11 blade to remove the covering from inside the lines drawn in the previous step. 14 E-flite Ascent PNP Assembly Manual
12. Use medium CA to glue the skid to the bottom of the stabilizer. Required Parts Receiver Motor battery Required Tools and Adhesives Phillips screwdriver: #1 Receiver Installation Hook and loop tape Fuselage assembly 1. Use a #1 Phillips screwdriver to remove the two screws that secure the canopy to the fuselage. E-flite Ascent PNP Assembly Manual 15
Page 1 and 2: Ascent 450 BL Park Glider PNP Assem
Page 3 and 4: Contents of Kit/Parts Layout Replac
Page 5 and 6: Damage Limits HORIZON SHALL NOT BE
Page 7 and 8: Wing Assembly Required Parts Fusela
Page 9 and 10: 2. Mark the center of the tail boom
Page 11 and 12: 8. Step back and view the airframe
Page 13: 5. Use a hobby knife with a new #11
Page 17 and 18: Control Throws 1. Turn on the trans
Page 19 and 20: Glide Testing Your Ascent PNP We st
Page 21 and 22: Sometimes the wind will cause the t
Page 23 and 24: • Pitch Attitude In-Flight Adjust
Page 25 and 26: 2008 Official AMA National Model Ai
Page 27 and 28: E-flite Ascent PNP Assembly Manual

Ascent 450 BL Park Glider PNP - E-flite

Create successful ePaper yourself

Delete template?

Save as template?