Ascent 450 BL Park Glider PNP - E-flite
Ascent 450 BL Park Glider PNP - E-flite
Ascent 450 BL Park Glider PNP - E-flite
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5. Use a hobby knife with a new #11 blade to remove<br />
the covering from the bottom of the fin.<br />
<br />
6. Reposition the fin and connect the rudder pushrod<br />
to the rudder control horn. The bend will enter the horn<br />
from the side of the horn closest to the stabilizer. You will<br />
need to put a small bend in the pushrod wire to connect<br />
it to the rudder.<br />
Important: Use light pressure when cutting the covering<br />
to prevent cutting into the fin. Cutting too deep will<br />
weaken the fin and could cause it to fail in flight.<br />
<br />
7. Use a square to check the alignment between the<br />
stabilizer and fin.<br />
E-<strong>flite</strong> <strong>Ascent</strong> <strong>PNP</strong> Assembly Manual<br />
13