14.11.2012 Views

FALCOM JP18 GPS receiver - Hardware manual

FALCOM JP18 GPS receiver - Hardware manual

FALCOM JP18 GPS receiver - Hardware manual

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>JP18</strong> <strong>FALCOM</strong> <strong>GPS</strong> RECEIVER VERSION 1.0.7<br />

9 FIRST STEPS TO MAKE IT WORKS...............................................................27<br />

10 APPENDIX..........................................................................................29<br />

10.1 How to put the <strong>JP18</strong> into power saving modes?......................................................29<br />

Version history:<br />

This table provides a summary of the document revisions.<br />

Version Author Changes Modified<br />

1.0.7 F. Beqiri<br />

- Added power consumption in Hibernate/Standby state - see Figure 3.<br />

- SiRF input messages 0x82 and 0x95 are not supported - see Table 7.<br />

- SPI bus is not supported in the current software. Depending on purchase order quantity it is<br />

possible to make a variant of the software that supports the SPI interface. For more information<br />

please contact our sales department.<br />

25/01/2010<br />

1.0.6 F. Beqiri<br />

- Added key characteristics of power management modes, see chapter 5.5.2.<br />

- In the <strong>JP18</strong> hardware revision "4d", the ON/OFF pin is pulled low through a 47 kΩ.<br />

11/02/2009<br />

1.0.5 F. Beqiri - VRTC_REG_IN must be always connected to the VCC pin. 06/06/2008<br />

1.0.4 F. Beqiri<br />

- The firmware version ROM is very early (engineering proof) and was never intended for<br />

production use.<br />

23/05/2008<br />

1.0.3 F. Beqiri<br />

- Power consumption in the Hibernate state is replaced to “To be defined” - see Fig. 3.<br />

- The ON/OFF pin works only in the FLASH mode.<br />

17/03/2008<br />

1.0.2 F. Beqiri - <strong>JP18</strong> module can accept only one reflow process.<br />

- Replaced Fig.1 by a new one.<br />

25/09/2007<br />

- Added standards for handling ESD sensitive devices – see chapter 2.5.<br />

1.0.1 F. Beqiri - <strong>JP18</strong> module is classified as a MSL3 device – see chapter 2.6.<br />

- Throughout this documentation the input voltage range of VRTC_REG_IN and VCC has<br />

changed from 3.4 .. 5.5 to 3.3 .. 5.5 V.<br />

- Added description of pin ON/OFF- See chapter 6.2, page 22<br />

12/09/2007<br />

1.0.0 F. Beqiri - Initial version 05/07/2007<br />

This confidential document is the property of <strong>FALCOM</strong> and may not be copied or circulated without permission.<br />

Page 3

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!