4 - HUBER

Compressor
Auto
Heating
Capacity
Software
version
4. Thermoregulation via
Controller
4.3. 4.2. Editing Wichtige Default Voreinstellungen
Settings
prüfen und ändern
10. Compressor Automatic
11. Maximum 1. Programm Heating 52: Power Rückführung auf Werkseinstellung
12. Software 2. Programm Version90:
Sprachauswahl Digitalanzeige UniCop
13. Softwareversion
All the factory defaults can be customized in the menu.
All the factory defaults can be restored via the „Factory Default“ option
(with the thermoregulation function switched off). (Also refer to „Salutation“
4.1).
MAIN MENU:
Calibration Prog.
I-> Compressor Auto
Mains Failure Auto
COMPRESSOR AUTO:
I-> Automatic
Always on
Always off
MAIN MENU:
Machine options
I-> Max. heat power
Calibration Prog.
Please enter:
Max. heat power (%)
100
MAIN MENU:
Acoustic alarm
I-> Software version
Set-Point limits
SOFTWARE:
Series No.: 0
Version 04.00s
Date 19.02.03. 15.41
Selection of the compressor starting mode
„Automatic“
The compressor will start automatically
depending on the topical demand. The chiller
will work on demand only.
Benefit: Saving of energy.
Drawback: Heating time (idle time) in the case
of a sudden demand.
„Always On“
The compressor remains switched on,
continuous chiller operation.
„Always Off“
The compressor remains switched of, the
chiller is not in operation.
„Max. Heat Power“ option
Enter the desired maximum heating power in
percent.
This is required for devices equipped with a
heater and a compressor (chiller).
The heating power must be reduced to enable
simultaneous operation of heater and
compressor with a view to the fusing of the
device.
„Software Version“ option
For example:
04.00s vom 19.02.2003, 15.41 PM.
43-4