Version 23 BobNEST Lesson - BobCAD-CAM

More documents

Recommendations

Info

Version 23 BobNEST Lesson 13. For this example we are going to be using one 48 x 36 sheet. Simply change the length to 48 and the width to 36. The reference point can be left alone. 14. Now that the sheet is defined, click the Next button to move to the Nesting Parameters page. Real Solutions for Global Manufacturing 6
Version 23 BobNEST Lesson 15. In this example, we will want to leave Generate tool path before nesting checked, since we do want to create the tool path for this nested result. Otherwise the nesting system will only nest the parts and will not generate any tool path. The Cutting Direction, Start/Direction, and Toolpath Pattern can be left at the defaults. 16. The Machining Order group can be ignored since we are simply profiling in this example, as we have no holes or Dadoes. 17. The Cutting Order can be left to By Part, meaning each part will be completely cut from the stock before moving to the next part. Inner profiles will also be cut before the outer profile of the part. If we were to switch to By Sheet, then all of the inner profiles will be cut for the entire sheet, before returning to cut the outside profiles of each part. 18. For this example we will leave the Bridge Distance set to 0, because we want to nest these parts as closely together as we can. 19. Set the Stock Margin to 0.5000 to leave a margin around the outside of the sheet. 20. Now that our Nesting Parameters are complete, click the Next button to move to the tool definition page. Real Solutions for Global Manufacturing 7
Page 1 and 2: Version 23 BobNEST Lesson Version 2
Page 3 and 4: Version 23 BobNEST Lesson 7. Once a
Page 5: Version 23 BobNEST Lesson 11. Click
Page 9 and 10: Version 23 BobNEST Lesson 23. The N
Page 11 and 12: Version 23 BobNEST Lesson 27. The s
Page 13 and 14: Version 23 BobNEST Lesson 5. In ord
Page 15 and 16: Version 23 BobNEST Lesson 9. Now th

Version 23 BobNEST Lesson - BobCAD-CAM

Create successful ePaper yourself

Delete template?

Save as template?