Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Bolt hole<br />
pattern<br />
around a<br />
portion of the<br />
circumference<br />
of a circle<br />
When the start angle and the end angle are not the same, the Mill <strong>Pro</strong> will place the first<br />
hole at the start arigle position and the last hole at the end angle position. The remaining<br />
START ANGLE 1 90 dEgTCES<br />
+Y<br />
4 Holes, evenlY sPaced<br />
Radius = 0.5000 inches<br />
Hole 1<br />
180 degrees -X +X 0 degrees, 360 degrees<br />
-Y<br />
END ANGLE 4 270 degrees<br />
In order to create the bolt hole pattern shown above, the following information must be<br />
programmed into the Mill <strong>Pro</strong>:<br />
RADIUS 0.5000 inches<br />
START ANGLE<br />
90 degrees<br />
END ANGLE<br />
270 degrees<br />
NUMBER OF HOLES 4<br />
Enter the<br />
BOLT mode<br />
Exit the BOLT<br />
mode<br />
press the heXt key to scroll the MENU (section6,page l0) , until the Bo[ris<br />
displayed on the screen. press the X, the Y orthe z key whicheverhappen to coincide<br />
BoLrhole<br />
with the BOLT<br />
mode as below.<br />
05frcn<br />
| frd tus<br />
Press the ffiehU or the Cleal key to exit bolt hole mode'<br />
Once in BOLT mode, press the lleXt key to<br />
view or edit the BOLf hole program or<br />
press the Stdlt key to run the current BOLT<br />
hole program.<br />
16
Change language