Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Cleari ng Al I Memory<br />
CAUTION<br />
The following will occur when memory is cleared:<br />
. Resolutions will be set to 0.0005 inches or 10 micron.<br />
' Scale directions will be set to negative.<br />
. Diameter will be disabled for all axes.<br />
. Near Zero Warning window will be set to * 0.2000 inch.<br />
. Bolt hole, Concave, Convex and Line hole programs will be replaced by sample<br />
demo programs.<br />
. Position information will be lost.<br />
. MEC factors will be set to 1.0.<br />
. All other stored information will be lost.<br />
Selecting<br />
clear all<br />
I LEHT<br />
frLL<br />
After power up and while the display is still<br />
flashing 8.8.8.8.8.8.8.8., press and hold<br />
the clear key to display the CLEAR<br />
ALL screen. To cancel the CLEAR ALL,<br />
press any key except the Xkey.<br />
Press the X key. The Mill <strong>Pro</strong> will prompt<br />
with CLEAR YES ?<br />
ELEHI<br />
TE5<br />
To CANCEL the CLEAR ALL operation,<br />
press any key except the Z key.<br />
To CONTINUE the CLEAR ALL<br />
operation, press the Z k"y. CLEARED will<br />
be momentarily displayed and all memory<br />
will be cleared. The Mill <strong>Pro</strong> will then<br />
automatically go to the setup screens<br />
(Section 5.)<br />
Exiting without<br />
clearing<br />
memory<br />
To exit the clear all screen without clearing memory, press any key except the X and<br />
the Zkey. The Gold Tracer will switch to the NORMAL mode automatically.<br />
6
Change language