Mlll Pro - Digital readouts, DRO, Magnum Measuring Systems, sargon

Creating a line
hole program
You can change the parameters (length, angle and holes) on each screen to create a
LINE hole program, press the fleXt key to get to the next screen.
If you like to run the program in the Mill Pro's memory, press the St?ft key.
i5000
L E NDLH
fr Ll1nfr
frn"L E
Pressing the X to enter the desired LINE
segment length from first hole to final hole if
different from the displayed value.
To view or change the next parameter press the
next key.
Pressing the X to enter the desired ANG LE of
the line segment if different than the displayed
value.
To view or change the next parameter press the
ll€Xt key
HfrLE5
Pressing the X key to enter the desired number
of HOLES if different than the displayed value.
[- E [ 1frUE
E [-t d P{- frL
neit page
Press the heXt key to save the program.
When the REC SAVE screen is displayed, the
program has been stored in the Mill Pro's
memory.
Press the Il€Xt key to run the
program(continued on next page.)
20