TRU 8885 SERIES OWNER'S MANUAL - C. Crane Company

Recording a conversation
You can record a conversation from the handset or the base (more than 2 seconds
and less than 10 minutes).
1) During a conversation, press the MENU soft key.
2) Press volume up/down to select Call Record, and then press the OK soft key.
Recording a Call appears on the display.
A confirmation tone, that can be heard by both parties, sounds during recording.
3) To stop recording:
From Handset - press the MENU soft key and /vol/∧ or /vol/∨ to select Call
Record. You will hear a confirmation tone.
From Base - press play/stop. Or press the MENU soft key and /volume/ or
/volume/ to select Call Record. You will hear a confirmation
tone.
Screening a call
From the base
To screen an incoming call, use the following steps:
1) After the answering system answers, the base speaker will let you hear the calls
as the machine records the message. To adjust the volume, press /volume/
or /volume/ . If you set the answering system to off, you cannot screen a
call.
note
•Every state has
different regulations
governing the
recording of
conversations over the
telephone. Make sure
to check your local,
state and federal laws
before using this
product to record any
telephone
conversation in order
to determine that your
use is in compliance
with such laws or
guidelines.
•To active this feature,
you must turn the Call
Screen feature on. See
“Answering System
Setup“, “Setting the
Call Screen“ on
page 28.
THE INTEGRATED
ANSWERING DEVICE
www.uniden.com
THE INTEGRATED ANSWERING DEVICE [61]