TRU 8885 SERIES OWNER'S MANUAL - C. Crane Company

Symptom
Severe noise interference.
The Caller ID does not display.
You cannot register the handset
at the base.
The handset doesn't
communicate with other
handsets.
An extra handset can't join
the conversation.
The handset or the base can't
join the conversation
The answering system does
not work.
Messages are incomplete.
After a power failure, the
outgoing message is deleted.
Suggestion
• Keep the handset away from microwave ovens, computers, remote control toys, wireless
microphones, alarm systems, intercoms, room monitors, fluorescent lights, and electrical
appliances.
• Move to another location or turn off the source of interference.
• The handset was picked up before the second ring.
• The call was placed through a switchboard.
• Call your local telephone company to verify your Caller ID service is current. There may be a
problem with your Caller ID service.
• Charge the battery pack for 15-20 hours.
• De-register the handset (see "De-register the Handset" on page 32) and register the handset
(see "Register the Handset" on page 67).
• De-register the handset (see "De-register the Handset" on page 32) and register the handset
(see "Register the Handset" on page 67).
• Make sure that you have registered all handsets.
• Make sure there are not 2 handsets already using the 3-way conference feature.
• Make sure that another handset or base is in privacy mode.
• Make sure the base unit is plugged in.
• Make sure that the answering system is turned on.
• Make sure that the message record time is not set to Announce only (see page 26).
• The incoming messages may be too long. Remind callers to leave a brief message.
• The memory may be full. Delete some or all of the saved messages.
• Record your greeting again. The default message should remain.
TROUBLESHOOTING
www.uniden.com
TROUBLESHOOTING [77]