Operating Instructions MxxMA-MxERA Three-phase AC ... - Lenze
Operating Instructions MxxMA-MxERA Three-phase AC ... - Lenze
Operating Instructions MxxMA-MxERA Three-phase AC ... - Lenze
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8<br />
Maintenance/repair<br />
Installation of a spring−applied brake<br />
Installation of the brake<br />
2. Lightly lubricate the lip of the shaft seal with grease.<br />
3. When assembling the stator (7) push the shaft seal carefully over the shaft.<br />
– The shaft should be located concentrically to the shaft seal.<br />
4. Use the screws (10) to mount the stator (7) completely to the end shield (15).<br />
– Tighten the screws evenly, tightening torque ( 51).<br />
<br />
9<br />
10<br />
7<br />
Fig. 4<br />
Torque adjustment<br />
7 Stator 9 Threaded sleeve s Lürated<br />
10 Allen screw<br />
KL458−012−a<br />
1. Check the air gap "s Lü " near the screws (10) using a feeler gauge and compare the<br />
values to the values for "s Lürated " in the table ( 51).<br />
Note!<br />
Do not insert feeler gauge more than 10 mm between armature plate (2) and<br />
stator (1.1)!<br />
If "s Lü " ( 51) is not within the tolerance, readjust the air gap.<br />
52 <br />
BA 33.0005−EN 2.0