70 Series Maintenance Training Manual - Automation Service Srl

2. Maintenance Screen
2.2 All Backup Screen
Menus
Menu Details Type Reference
Psswd
input
PLC
stop
All
backup
System
setup
Adjust
S-ana
To
Abs pos
AUX
test
Collect
set
Format
This changes the screen related to the maintenance by setting the
password.
This forcible stops the PLC ladder process. If this menu key is pressed
in the stopped state, the stop is canceled.
This backs up (saves) or restores (reloads) the file such as SRAM etc.
to designated device.
This automatically executes necessary parameter setting for driving
servomotor only by setting necessary minimum item.
This changes the screen to that for adjusting the spindle analog
output.
This sets the absolute position for servo axis (arbitrary NC axis, PLC
axis).
This carries out absolute position setting or test operation by the
auxiliary axis forward run/reverse run.
This menu is only for 700 series.
This executes the followings.
Setting to collect the diagnosis data
Confirming the diagnosis data collection status
Starting/Stopping to collect the diagnosis data
Clearing the diagnosis data
This formats the NC memory.
A
C
C
C
C
C
C
C
B
T-life
format
Serial
No.Set
Console
exec
To
In/out
To
param
SRAM
backup
HMI
Quit
This formats the tool life management data.
This changes the NC serial No.
The console is executed. The MS-DOS window will appear.
This changes the screen to the Data Input/Output screen.
This changes the screen to the Parameter screen.
This backs up the NC SRAM information on the HD.
This backs up the NC SRAM information on the memory card.
This quits the screen operation.
B
A
C
C
C
B
B
29