z/OS V1R6.0 DFSMS Access Method Services for Catalogs

*(AREAS -(ZZ LC))LISTCAT -LEVEL(SYS1) -ALLPARM -TEST(OFF)Condition CodesThe PARM command parameters are:vvTEST indicates diagnostic testing is to be done.AREAS(ZZ LC) specifies that trace tables and selected areas of storage areprinted. This information is used by service personnel for diagnostic purposes.The csondition codes that are tested in the IF-THEN-ELSE command sequence are:0 The function ran as directed and expected. Some informational messagescan be issued.4 A problem occurred in executing the complete function, but it continued.The continuation might not provide you with exactly what you wanted,but no permanent harm was done. A warning message appears. Anexample is:The system was unable to locate an entry in a LISTCATcommand.8 A requested function was completed, but major specifications wereunavoidably bypassed. For example, an entry to be deleted or alteredcould not be found in the catalog, or a duplicate name was found while anentry was being defined and the define action ended.12 The program could not perform requested function. The program sets thiscondition code as a result of a logical error. A logical error condition existswhen inconsistent parameters are given, when required parameters aremissing, or when a value for key length, record size, or buffer space is toosmall or too large. More information on logical errors that occur duringVSAM record processing is in z/OS DFSMS Macro Instructions for Data Sets.16 A severe error occurred that erased the remainder of the command stream.This condition code results from one of the following:vvvThe program cannot open a system output data set. (For example, aSYSPRINT DD statement was missing.)An irrecoverable error occurred in a system data setAn access method services encountered improper IF-THEN-ELSEcommand sequences.Condition codes that are tested in the IF-THEN-ELSE command sequence or set bythe SET command cannot be passed from one job step to the next. However, themaximum condition code value established by any previous functional commandor SET command is passed to the operating system when the access methodservices processor returns control to the system.Chapter 2. Modal Commands 25