IQ plus® 800/810 - Rice Lake Weighing Systems

SERIAL MenuParameter Choices DescriptionLevel 2 submenusEDPBAUDBITSTERMINEOL DLYADDRESSSpecifies settings for baud rate, data bits, termination characters, end-of-line delay, and portaddress used by the EDP port.PRINTERAUXSTREAMABSTRMBAUDBITSTERMINEOL DLYBAUDBITSTERMINEOL DLYADDRESSOFFEDPPRNAUXOFFEDPPRNAUXPRNDEST EDPPRNAUXLevel 3 SubmenusBAUD 480024001200600300192009600BITS7 ODD8 NONE7 EVENSpecifies settings for baud rate, data bits, termination characters, and end-of-line delay used bythe printer port.Specifies settings for baud rate, data bits, termination characters, end-of-line delay, and portaddress used by the auxiliary port. This parameter is valid only for units with expansion board PN19629 installed.Selects the serial port used for continuous transmission. The value AUX is valid only for units withexpansion board PN 19629 installed.Specifies which port uses the Allen-Bradley Remote I/O data stream. This parameter is valid onlyif the Remote I/O option is installed.Print destination. Selects the port for data transmission when the PRINT key is pressed or theKPRINT EDP command is sent. The value AUX is valid only for units with expansion board PN19629 installed.EDP PortEDP port baud rate. Selects the transmission speed for the EDP port.Selects number of data bits and parity of data transmitted from the EDP port.TERMIN CR/LF EDP port termination character. Selects termination character for data sent from the EDP portCREOL DLY number EDP port end-of-line delay. Sets the delay period, in 0.01-second intervals, from when aformatted line is terminated to the beginning of the next formatted serial output.ADDRESS number EDP port address. Specifies the address used for RS-485 communications. Valid addresses are01 through 255. An address of 0 turns off the RS-485 mode.Table 3-6. Serial Menu ParametersConfiguration 31