vacon 100 installation manual - VEM motors Finland Oy
vacon 100 installation manual - VEM motors Finland Oy
vacon 100 installation manual - VEM motors Finland Oy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Control unit <strong>vacon</strong> • 56Strip about 15 mm of the RS485 cable (see specification on page 55) and cut offthe grey cable shield. Remember to do this for both bus cables.Leave no more than 10 mm of the cable outside the terminal block and strip thecables at about 5 mm to fit in the terminals. See picture below.101Also strip the cable now at such a distance from the terminal that you can fix it tothe frame with the grounding clamp. Strip the cable at a maximum length of 15mm. Do not strip the aluminum cable shield!52Then connect the cable to its appropriate terminals on Vacon <strong>100</strong> AC drive standardterminal block, terminals A and B (A = negative, B = positive). See Figure 53.RS485terminals(A and B)21 22 23 24 25 26 282912 13 14 15 16 17 18 19 20 A B20 AB1 2 3 4 5 6 7 8 910118 9 10 11Figure 53.24-hour support +358 (0)201 212 575 • Email: <strong>vacon</strong>@<strong>vacon</strong>.com5
Change language