Installation and Operation Manual For Hunter Ceiling ... - Hunter Fan

®INSTALLING INCLUDED SINGLE-GLOBE LIGHT FIXTURE1. Remove the plug cap from thelower switch housing.Note: Do not discard the plugcap. You will need this if you removethe light fixture in the future.2. Locate the two wires in the lowerswitch housing labeled “ConnectLight Here” or “For Light Use”.One will be white, the other black/white. Unscrew the wire nutscounterclockwise to expose thebare metal leads.3. Locate the white wire and theblack wire coming from the lightfixture.4. Thread the two wires from thelight fixture through the centerhole in the lower switch housing.5. Screw the fixture into the lowerswitch housing. Thread thelockwasher and nut provided overthe wires. Making sure the lightfixture mounting screw holes arealigned; hold the light fixture andtighten the nut on the inside ofthe lower switch housing. Insertand tighten the two #6-32 semslight fixture mounting screws.6. Connect the black wire from thelight fixture to the black/whitewire from the lower switch housing.See Figure 10b.Connect the white wire from thelight fixture to the white wire fromthe lower switch housing. See Figure10b.To fasten the wires, twist the twobare leads together. Place a wirenut over the intertwined lengthof wire and twist clockwise untiltight.CAUTIONBe sure no bare wire or wirestrands are visible after makingconnections.Black/WhiteWire fromSwitch HousingBlack Wirefrom LightFixtureWhite Wirefrom SwitchHousingWire NutWhite Wirefrom LightFixtureLightFixtureFigure 10b - Wiring Light Fixture toFan2441524-01 9-5-2001