ig6000 service - Kipor Power Systems

Measure the spark plug gap and performthe spark test.Standard gap: .028-.034 in. (0.7-0.8 mm)↓no sparkPerform the spark test again using a new →normal Replace the spark plugspark plugspark↓no sparkPerform the spark test again using a new →normal Replace Ignitorignitorspark↓no sparkDisconnect low oil alarm and perform theReplace low oil alarm→abnormalspark test.↓no sparkCheck the ignition control moduleReplace the ignition module↓normalCheck resistance of motor ignition winding →abnormal Replace the motor rotor↓normalCheck trigger air gap and triggerAdjust the air gap and/or replace the trigger→abnormalresistance↓normalCheck the ignition coil resistance and highCheck the ignition coil→abnormalvoltage cable and insulation cap↓Check or replace wiring harnessd. Engine oil level is low, but engine does not stop.Drain out all engine oil, disconnect thelow oil alarm wire and check if the outletterminal is connected to ground↓conductiveConnect the alarm wire, loosen ignitionmodule receptacle and check if theorange wire is connected with the ground↓conductiveReplace ignition module→notconductive→notconductiveReplace the oil level alarm switchRepair or replace wiring harnesse. Engine speed does not increase or is unstableCheck air filter element for clog clogged Clean air filter element↓not cloggedCheck the valve clearance→abnormal Adjust the valve clearance↓normalRemove the spark plug and check theClean the spark plug and adjust the spark→abnormalelectrodes for carbon and spark plug gapplug gap or replace new spark plug14