ig6000 service - Kipor Power Systems

More documents

Recommendations

Info

$H:\drawings\IG3000\KG205GETi(EPA)(CARB)å¾å.dwg Model (1)$

●Alignment of time setting marksAlign camshaft with comparison marks of time setting gear (small gear on camshaft) before installing.c. Piston and connecting rod44
Assemble of piston ringCaution● Put the manufacturer mark facing up when installation;● Pay attention to the installation positions of 1 st and 2 nd ring.● Check if the piston ring can rotate freely after installing.● All openings of piston ring should be kept away from the direction of piston pin with 120 degree angle.10.2 InspectionInspection of low oil alarm(1)Lift the low oil alarm and measure the conductivity between lead wire and copper grounding pieceusing instrument.2)Convert the low oil alarm and measure again, it should be not conductive.3)Dip the low oil alarm into engine oil in order to inspect float, and measure again, it should be notconductive.●Noise and moving of shaftClean and dry the shaft, rotate the shaft manually and check the free gap; if any noise or moving, replacethe shaft.45
Page 1 and 2: Kipor Power Systems August 1, 2011I
Page 3 and 4: TABLE of CONTENTS1. Specifications.
Page 5 and 6: 1.2 Generator SpecificationsModelIG
Page 7 and 8: 1.5 Wiring Diagrama. Single voltage
Page 9 and 10: 2. SERVICE and MAINTENANCE2.1 The i
Page 11 and 12: • Clamp the wire harnesses secure
Page 13 and 14: Alternator Maintenance StandardsSta
Page 15 and 16: the electrode on the cylinder head.
Page 17 and 18: ↓normalCheck each carburetor hole
Page 19 and 20: Disconnect the two 6P input connect
Page 21 and 22: 3. INSPECTION AND ADJUSTMENT3.1 MAI
Page 23 and 24: (2) Stop the engine and disconnect
Page 25 and 26: 3.6 Valve clearance adjustment! Att
Page 27 and 28: 4.AIR CLEANER and MUFFLER4.1 Air cl
Page 29 and 30: 5.CARBURETORWARNING■ Loosen the g
Page 31 and 32: 5.2 Stepping motor/ fuel shutoff so
Page 33 and 34: Color of wire Circuit unit Stipulat
Page 35 and 36: Yellow GreenWhiteRedBlueBlackBlackd
Page 37 and 38: 7.2 IG6000h handle assembly7.3 Vapo
Page 39 and 40: 8.2 Ignition coil and triggera. Dis
Page 41 and 42: 8.3 Alternatora. Disassembly and re
Page 43 and 44: 9.2 Inspection● Valve spring leng
Page 45: 10. CRANKCASE COVER, CAMSHAFT, PIST
Page 49 and 50: ● Terminal clearance of piston ri
Page 51 and 52: ● External diameter of crankshaft

ig6000 service - Kipor Power Systems

Create successful ePaper yourself

Delete template?

Save as template?