T Catalogue 2010 - Tridonic

U – LED modules, converters and systemsumoduleNEWUstrip P110-3/111-3ustrip, white / RGBAProduct description• LED strip module for highlighting lines and edgesand for side injection• For safety lighting, general lighting, effect lighting and shelf lighting• Suitable for LED profile Z200-2 / 201-2 / Z204, Z22W-2• Edge injection of transparent or diffuse materials• With maximum possible beam angle for uniform illumination• Low profile• Simple installation thanks to pre-fitted adhesive tape• Dimmable by pulse width modulation (PWM)• Integrated current source to stabilise luminous flux• Beam characteristic: 140°• Attached with premounted thermally conductivedouble-sided adhesive tape• Connection: Cable 200 mmÊÊFor product data sheet go to www.tridonic.com,or available on requestTechnical dataAmbient temperature ta -25 ... +50 °Ctc point1 75 °CÈProduct matrix, page 20Standards, page 20Colour temperatures and tolerances, page 132Ordering dataColourWavelengthColourtemperatureTypeArticle number10 light points per moduleRed 619 – 629 nm – P110-3 R 89601054Amber 584 – 594 nm – P110-3 A 8960105312 light points per moduleDaylight white – 6,500 K P111-3 DL 89601044Neutral white – 4,200 K P111-3 NW 89601043Warm white – 3,000 K P111-3 WW 89601042Green 520 – 535 nm – P111-3 G 89601046Blue 450 – 460 nm – P111-3 B 89601045Packaging: 10 pieces/cartonSpecific technical dataType Typ. luminous flux 2 Supply voltage DC 3 Power2 Total length Colour rendering index Ra/Rff10 light points per moduleP110-3 R 70 lm 24 V 1.56 W 200 +/- 1 mm –P110-3 A 48 lm 24 V 1.56 W 200 +/- 1 mm –12 light points per moduleP111-3 DL 102 lm 24 V 1.92 W 200 +/- 1 mm 75P111-3 NW 83 lm 24 V 1.92 W 200 +/- 1 mm 80P111-3 WW 73 lm 24 V 1.92 W 200 +/- 1 mm 80P111-3 G 30 lm 24 V 1.92 W 200 +/- 1 mm –P111-3 B 25 lm 24 V 1.92 W 200 +/- 1 mm –1 If the max. temperature limits are exceeded, the life of the module will be reduced or the module may be damaged. The temperatureof the ustrip at the tc-point is to be measured in the thermally stable state. For tc-point see the above diagram.2 Tolerance range for optical and electrical data: ±15 %.3 Exceeding the max. operating voltage leads to an overload on the ustrip. This may in turn result in a significant reduction in lifetimeor even in destruction. Tolerance range for the supply voltage: 24 V: +2 V / -0 V.All values at ta = 25 °C.T Catalogue 2010www.tridonic.com 63