EMPIRE - White Mountain Hearth

OPERATION INSTRUCTIONS/FLAME APPEARANCEFlames from the pilot (rear right back side of the burner) as wellas the main flame should be visually checked as the log set isinstalled.In normal operation at full rate after 10 to 15 minutes, the flameappearance should be sets of yellow flames.NOTICE: All flames will be random by design, flame height will goup and down.Avoid any drafts that alter burner flame patterns. Do not allow fans toblow directly into fireplace. Do not place a blower inside the burnerarea of the firebox. Ceiling fans may create drafts that alter flamepatterns. Sooting and improper burning will result.During manufacturing, fabricating and shipping, various componentsof this appliance are treated with certain oils, films or bonding agents.These chemicals are not harmful, but may produce annoying smokeand smells as they are burned off during the initial operation of theappliance, possibly causing headaches or eye or lung irritation. Thisis a normal and temporary occurrence.The initial break-in operation should last 2-3 hours with the burnerat the highest setting. Provide maximum ventilation by openingwindows or doors to allow odors to dissipate. Any odors remainingafter this initial break-in will be slight and will disappear withcontinued use.PERIODIC CLEANING – Refer to parts diagram for location ofitems discussed below.• Do not use cleaning fluid to clean logs or any part of heater.• Logs - brush with soft bristle brush or vacuum with brushattachment.• Remove loose particles and dust from the burner areas,controls, piezo covers and grate.• Inspect and clean burner air intake hole. Remove lint or particleswith brush. Failure to keep air intake hole clean will result insooting and poor combustion.ANNUAL CLEANING/INSPECTION – Refer to parts diagram forlocation of items discussed below.• Inspect and clean burner air intake hole. Remove lint or particleswith vacuum or brush. Failure to keep air intake hole clean willresult in sooting and poor combustion.• Inspect and clean all burner ports.• Inspect ODS pilot for operation and accumulation of lint at airintake holes.• Verify flame pattern and log placement for proper operation.• Verify smooth and responsive ignition of main burner.MAINTENANCEKeep the control compartment, logs and burner area surroundingthe logs clean by vacuuming or brushing area at least twice a year.WARNINGTHE LOGS CAN GET VERY HOT – HANDLE ONLY WHENCOOL.Always turn off gas to the pilot before cleaning. For relighting, referto lighting instructions located on the rating plate of the log set.Never obstruct the flow of the combustion and ventilation air. Keepthe front of the fireplace clear of all obstacles and materials.Leave at least 36" clearance from the front of the fireplace.Screen should be closed during operation.Page 1830816-1-0912