Drum Voice List - Yamaha

3-2. Click Tune
This sets the pitch for each of the 3 Click Voices.
UT SEQ Click= hi
Tune C= 0 F= 0
w e
q Click (Click Voice)
Selects the Click Voice. (The same Click Voice selected in function
3-1.)
w Tune C (Tune Coarse)
[Range] –24 to 0 to +24.
The Click Voice selected in step q will be tuned in increments of
a half-step.
e Tune F (Tune Fine)
[Range] –64 to 0 to +63.
The Click Voice selected in step q will be tuned in increments of
about 1.17 cents.
3-3. Click Note Number
Sets the MIDI Note Number for each of the 3 Click Voices.
q Click (Click Voice)
Selects the Click Voice. (The same Click Voice selected in function
3-1.)
w Note # (MIDI Note Number)
[Range] off, 1-127 (—, C#-2 to G8)
Sets the MIDI note number. The note number and note name will
be displayed.
If this is set to “off”, the DTXPRESS will produce sound however;
key on messages will not be transmitted.
* Refer to the preset drum kit’s [Drum Voice List] for the voice
assignment of each MIDI note number.
q
UT SEQ Click= hi q
Note#= 22 (A#-1) w
3-4. MIDI Control
Utility Mode
This enables or disables the DTXPRESS to transmit or receive
system real-time messages (start/continue/stop).
When this function is enabled, you can control an external sequencer
or rhythm machine from the DTXPRESS. Control of the
DTXPRESS from an external sequencer or rhythm machine is also
possible.
UT SEQ SETUP
MIDI Control=off
q MIDI Control
on: Transmits and receives the following system real-time messages.
• Transmits timing clock (F8) (transmit only)
• Transmits and receives start, stop, and continue
(FA, FB, FC)
off: Does not transmit or receive system real-time messages.
3-5. Count Switch
This function turns the 2 bar countdown before the song starts
playback, on or off.
UT SEQ SETUP
Count Switch=off
q Count Switch
on: After a 2 bar countdown, the song will start playback.
off: No countdown, the song will start playback immediately.
3-6. Sync Mode
This function synchronizes the DTXPRESS sequencer’s clock with
the clock of an external device.
UT SEQ SETUP
Sync Mode= auto
q Sync Mode
int: Movement is determined by the DTXPRESS’ internal clock.
ext: Movement is determined by the clock of an external device
received via the MIDI IN/TO HOST jacks.
auto: If a timing clock (F8) is received via the MIDI IN/TO HOST
jack the external clock will be used If a timing clock (F8) is
not received the internal clock will be used.
q
q
q
33