Drum Voice List - Yamaha

q N (MIDI Note Number)
Sets the MIDI note number (The same procedure as in [5-1. Voice]).
w Reverb send (Reverb Send Level)
[Range] 0-127
5-7. Alternate Group, Key Assign Mode
This sets the Alternate Group and Key Assign Mode for each drum
voice w assigned to each MIDI note number q.
The function and setting of the Alternate Group, Key Assign
Mode are the same functions and settings found in [2-3. Alternate
Group, Key Assign Mode] (P. 19) in the Drum Kit Voice Edit
Mode.
UT MAP N= 0C -2
AitG= 0 Key=semi
w e
q N (MIDI Note Number)
Selects the MIDI note number (The same procedure as in [5-1.
Voice]).
w AltG (Alternate Group)
[Range] 0-15
e Key (Key Assign Mode)
[Range] poly, semi, mono, high
5-8. Key Off Enable
This function decides whether or not to recognize key off messages
for each drum voice w assigned to each MIDI note number
q.
UT MAP N= 0C -2
Key Off= disable
q N (MIDI Note Number)
Selects the MIDI note number (The same procedure as in [5-1.
Voice]).
w Key Off
enable: Recognizes key off.
disable: Does not recognize key off.
* When this is set to “disable”, some voices may sound continuously.
Press the [SHIFT] and [VOICE] buttons to stop voices
sounding.
q
q
w
5-9. Map Copy
Utility Mode
This function copies the preset drum map’s entire internal settings
to a user drum map.
UT MAP Copy
from= 1Acoustic q
When the Map Copy function is used, the user drum
map’s internal settings will be erased and replaced
with the settings of the copy source. If you want to
keep important user drum map settings, use the bulk
dump operation and save the settings to an external
device before executing the map copy.
q from (Preset Drum Map)
Selects the preset drum kit number (1-48) that will be the copy
source. The drum kit number and drum kit name will be displayed.
Procedure
1. In the display shown above, assign the copy source drum
kit (drum map), press the [SAVE/ENT] button.
The following display will appear asking for confirmation
before the copy operation is carried out.
Copy Map From 1
Are you sure ?
2. Press the [SAVE/ENT] or [VALUE+] button, the copy
operation will be carried out.
* Press the [VALUE-] button to cancel the copy operation.
When the copy operation is complete, “Complete!” will
appear.
37