Napco Gemini LCD Keypad - Microtec

TURNING OFF THE ALARM (DISARMING) WHEN RETURNINGENTRY TIME XXXDISARM SYSTEMINVALID ENTRYTRY AGAIN**** ALARM ****02 - BACK ALARM03 - LIVING ROOMDisarming the System1 Enter your premises through the Entry/Exit door. The keypad will sound a steady tone toremind you to disarm the system before your Entry Delay time expires.2 Enter your User Code and pressJ. The red ARMED light will go out, indicating that thesystem has been disarmed.If you enter an invalid code, the keypad will beep 4 times, signifying an error. Re-enter yourcode immediately. 10 seconds before Entry Delay expires, the keypad will emit a pulsingwarning tone.Alarm Indication/Silencing an AlarmIf the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred whileyou were out. Proceed with caution! If you suspect that an intruder may still be on thepremises, leave immediately and call authorities from a neighbor's phone.To silence an audible alarm:Enter your code and press J. After the system is disarmed, the window will continue todisplay “ALARM” followed by the zone(s) violated. To reset the display, note the zonesviolated, then press C.Ambush (Optional - Ambush programmed? qYES qNO) (Your Ambush Code is __ __ )The Ambush Code (optional) is a 2-digit code that is entered just prior to your Disarm Code. If an intruder forces you to disarmyour system, (a) enter your Ambush Code; (b) enter your Disarm Code; (c) pressJ.Example: If your User Code is 1234 and your Ambush Code is 99, press 9 9 1 2 34J.This will send a silent alarm to the central station. The red ARMED light will go out and the window will display “SYSTEMREADY”, as if the system were merely disarmed. There will be no indication that an alarm has been sent.10