RENTAL Manual 2010 Engl. - Tyrolia

38 | Rental Ski Binding
Use of Non-Recommended
Settings
SKIERS REQUESTING SETTINGS NOT
RECOMMENDED BY HEAD/TYROLIA
The 2010.1 1 HEAD/TYROLIA Release/Retention Adjustment
Table is the only adjustment chart recommended
for use by HEAD/TYROLIA dealers during the 2010.11
season.
Some skiers may request settings different from those
in the HEAD/TYROLIA Release/Retention Adjustment
Table. Most of these concerns can be addressed by
following the procedures for reclassifying skier type and
for troubleshooting which follow the instructions for
using the HEAD/TYROLIA Release/Retention Adjustment
Table.
HEAD/TYROLIA and the ISO/ASTM standards organizations
do not recommend the use of release/retention
settings outside of these tolerances, but skiers occasionally
may request such settings. HEAD/TYROLIA recognizes
a skier’s right to choose other settings, but if the
skier requests settings outside of those derived from
the normal procedures for reclassifying skier type and
for trouble-shooting, the shop may either:
1. Adjust the system to the setting derived from HEAD/
TYROLIA Release/Retention Adjustment Table and
instruct the skier on how to change the setting (if
this done, make a note to this effect on the workshop
or rental form), or
2. Adjust the system to the skier’s individual request,
but only if the technician notes on the workshop or
rental form the reason the higher or lower setting
was requested. Do not in any case adjust the system
to a release/retention value higher than the maximum
acceptable setting at the bottom of the HEAD/
TYROLIA Release/Retention Adjustment Table. The
customer must verify the request for the higher or
lower settings by signing and dating the workshop or
rental form by the reason noted next to the setting
request. The skier must also read and sign a warning,
release and indemnity agreement identical to the
one printed on this page. In such cases, the system
will only be indemnified if all other conditions of
indemnification are met and the signed warning,
release and indemnity agreement are attached to
the completed work-shop or rental form.
Warning, Release and Indemnity Agreement
I, _________________________________________________________ ,
hereby acknowledge that I have been advised by the
_________________________________________ rental shop, sales
department, etc.) that settings which I have requested for my
bindings (Model _____________________) is not the setting recommended
by the manufacturer of the bindings for a skier
of my height, weight, age and skier type. I understand and
acknowledge that there may be an increased risk of injury or
death to me as a result of my own personal preference for
these binding settings.
To the fullest extent allowed by law, I hereby waive and
release all claims arising from the use of the bindings and
release from all liability the shop, the distributor and the
manufacturer, their agents and employees, and I further
agree to indemnify them from any and all liability or harm
or damage of any kind whatsoever which may result from
the use of these bindings by myself or anyone I allow to
use the bindings.
I, the undersigned, have read and understand this liability
release agreement, and agree that it is binding upon me,
my heirs, guardians, administrators, assigns, and legal
representatives. If any part of this agreement is held to be
invalid or unenforceable, the remainder shall be given full
force and effect.
__________________________________________________________
Skier’s Signature
(or that of the skier’s parent or guardian)
__________________________________________________________
Shop Manager’s Signature