4 channel surveillance - MikeCooperDesign.com

OPERATING INSTRUCTIONSRECORDING1 23 4A-REC [M] 39% 2009/02/22 16:09:441. Set up all the functions of the DVRfollowing “Programming the DVR”.2.AUDIOPress the record button to beginrecording according to the scheduleyou have set.Each Channel set to record will displaya recording symbol [ ] next tothe channel number.The channel which is set to audiowill display one of the following audiosymbols next to the record symbol.- Audio output is off.- Audio output is on and audiois attached to the indicated channel.When the symbol is red it indicatesthat audio is currently recording.To mute the audio signal, press theDOWN button. The audio signalwill continue to record and can beheard in playback mode.S-REC - Motion sensor recording.N-REC - No recording.OTHER DATAThe following will display along theremaining lower edge of the screen:[M] or [S]- Indicates which hard driveis in use (M=Master, S= slave).#% - Displays the percentage of harddrive disk space used.YYYY/MM/DD - Displays currentYear/Month/Day.HH:MM:SS - Displays current time(hours:minutes:seconds).Note: If the date, time or any othersettings are incorrect you will need tostop recording and go back to the setup menu to reset the functions.STOPPINGTo stop recording, press theSTOP button. If the password functionis enabled you will be promptedfor the password and will not be ableto stop recording without the currentpassword.RECORDING MODEOne of the following will display alongthe bottom left of the screen:A-REC - Normal recording.REV 10hSKU 67139 For technical questions, please call 1-800-444-3353. Page 13