2010 Nissan Murano Owner's Manual

CAUTION
. Keep the antenna as far away as
possible from the electronic control
modules.
. Keep the antenna wire more than 8
in (20 cm) away from the electronic
control system harness. Do not
route the antenna wire next to any
harness.
. Adjust the antenna standing-wave
ratio as recommended by the manufacturer.
. Connect the ground wire from the
CB radio chassis to the body.
. For details, consult a NISSAN dealer.
BLUETOOTH ® HANDS-FREE PHONE
SYSTEM WITH NAVIGATION
SYSTEM
WARNING
. Use a phone after stopping your
vehicle in a safe location. If you
have to use a phone while driving,
exercise extreme caution at all
times so full attention may be given
to vehicle operation.
. If you find yourself unable to devote
full attention to vehicle operation
while talking on the phone, pull off
the road to a safe location and stop
your vehicle before doing so.
CAUTION
To avoid draining the vehicle battery,
use a phone after starting the engine.
Your NISSAN is equipped with Bluetooth ®
Hands-Free Phone System. If you are an owner
of a compatible Bluetooth ® enabled cellular
phone, you can set up the wireless connection
between your cellular phone and the in-vehicle
phone module. With Bluetooth ® wireless technology,
you can make or receive a telephone call
with your cellular phone in your pocket.
procedure is required anymore. Your phone is
automatically connected with the in-vehicle
phone module when the ignition switch is
pushed to the ON position with the registered
cellular phone turned on and carried in the
vehicle.
You can register up to 5 different Bluetooth ®
cellular phones in the in-vehicle phone module.
However, you can talk on only one cellular phone
at a time.
The NISSAN Voice Recognition system supports
the phone commands, so dialing a phone
number using your voice is possible. For more
details, see “NISSAN VOICE RECOGNITION
SYSTEM (models with navigation system)” later
in this section; page 4-99.
Before using the Bluetooth ® Hands-Free Phone
System, refer to the following notes.
. Set up the wireless connection between a
cellular phone and the in-vehicle phone
module before using the Bluetooth ®
Hands-Free Phone System.
. Some Bluetooth
Once your cellular phone is paired to the invehicle
phone module, no phone connecting
® enabled cellular phones
.
may not be recognized by the in-vehicle
phone module. Please visit
www.nissanusa.com/bluetooth for a recommended
phone list.
You will not be able to use a hands-free
phone under the following conditions:
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-75