2010 Nissan Murano Owner's Manual

When prompted by the system, say the name
you would like to give the new entry (voicetag).
For example, say: “Mary.”
If the name is too long or too short, the system
tells you, then prompts you for a name again.
Also, if the name sounds too much like a name
already stored, the system tells you, then
prompts you for a name again.
Once the system accepts the name and you
confirm it is correct, the system asks for a
location (Home, Office, Mobile or Other).
SAA1928 For example, say: “Home.”
PHONE BOOK
The system acknowledges the location.
The Phone Book stores up to 40 names for each
phone paired with the system. Each name can
have up to 4 locations/phone numbers asso-
The system will ask you to say a phone number
or to transfer a phone number stored in the
cellular phone’s memory.
ciated with it.
To enter a phone number by voice command:
NOTE:
For example, say: “five five five one two one
Each phone has its own separate phone two.” (See “How to say numbers” earlier in this
book. You cannot access Phone A’s phone section for more information.)
book if you are currently connected with
Phone B.
To transfer a phone number stored in the cellular
phone’s memory (if so equipped):
“New Entry”
Say “Transfer entry.” The system acknowledges
Use the New Entry command to store a new the command and asks you to initiate the
name in the system.
transfer from the phone handset. The new
contact phone number will be transferred from
4-92 Monitor, heater, air conditioner, audio, phone and voice recognition systems
the cellular phone via the Bluetooth ® communication
link.
The transfer procedure varies according to each
cellular phone. See the cellular phone Owner’s
Manual for details. You can also visit
www.nissanusa.com/bluetooth for instructions
on transferring phone numbers from NISSAN
recommended cellular phones.
The system repeats the number and prompts
you for the next command. When you have
finished entering numbers, choose “Store.”
The system confirms the name, location and
number. The system then asks if you would like
to store another location for the same name. If
you do not wish to store another location, the
system ends the VR session.
“Edit”
Use the Edit command to alter an existing phone
book entry or to add a 2nd, 3rd or 4th phone
number to an existing entry.
When prompted by the system, say the name of
the entry you wish to edit.
The system acknowledges the name and asks
you for the location you would like to edit.
Say the name of the location.
The system acknowledges the location.