2010 Nissan Murano Owner's Manual

“Select Ring tone”
Use the Select Ring tone command to select the
tone heard in the vehicle when an incoming call
is received.
The system announces the name of the active
phone and asks you to choose from the
following commands:
. “Ringtone” — The system plays a ringtone
and asks if you would like to select that tone.
If you say no, the system plays the next
ringtone available and continues to cycle
through the ringtones until you select one or
quit.
memory locations are in use, the system will ask
the user to select which memory location should
be overwritten.
Training procedure
The procedure for training a voice is as follows.
1. Position the vehicle in a reasonably quiet
outdoor location.
2. Sit in the driver’s seat with the engine
running, the parking brake on, and the
transmission in the P (Park) position.
3. Press and hold the button for more
than 5 seconds.
. “Silent” — The system asks you to confirm 4. The system announces: “Press the PHONE/
your wish to disable the ringtone.
SEND ( ) button for the hands-free
SPEAKER ADAPTATION (SA) MODE
phone system to enter the speaker adaptation
mode”.
Speaker Adaptation allows up to two out-of
dialect users to train the system to improve
recognition accuracy. By repeating a number of
commands, the users can create a voice model
of their own voice that is stored in the system.
The system is capable of storing a different
speaker adaptation model for memory A and
5.
6.
Press the button.
Voice memory A or memory B is selected
automatically. If both memory locations are
already in use, the system will prompt you to
overwrite one. Follow the instructions provided
by the system.
memory B.
7. When preparation is complete and you are
If memory A is available, the system will use ready to begin, the press the button.
memory A to store the model. If memory A is in
use and memory B is available, the system will
use memory B to store the model. If both of the
8. The SA mode will be explained. Follow the
instructions provided by the system.
4-96 Monitor, heater, air conditioner, audio, phone and voice recognition systems
9. When training is finished, the system will tell
you an adequate number of phrases have
been recorded.
10. The system will ask you to say your name.
Follow the instructions to register your
name.
11. The system will announce that speaker
adaptation has been completed and the
system is ready.
The SA mode will stop if:
. The button is pressed for more than 5
.
seconds in SA mode.
The vehicle is driven during SA mode.
. The ignition switch is pushed to the OFF or
LOCK position.
Training phrases
During the SA mode, the system instructs you to
say the following phrases.
(The system will prompt you for each phrase.)
. phone book new entry
. dial three oh four two nine
. delete call back number
. setup pair phone
. memo pad play