PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

More documents

Recommendations

Info

section 4operationcautionBefore attempting ANY corrections, check cutting variables with thefactory recommended settings/consumable part numbers listed inProcess Data.4.2.2. Cut AngleNegative Cut AngleTop dimension is greater than the bottom.•••••Misaligned torchBent or warped materialWorn or damaged consumablesStandoff low (arc voltage)<strong>Cutting</strong> speed slow (machine travel rate)PartDropPartPositive Cut AngleTop dimension is less than the bottom dimension.••••••Misaligned torchBent or warped materialWorn or damaged consumablesHigh standoff High (arc voltage)<strong>Cutting</strong> speed fastCurrent high or low. (See Process Data for recommendedcurrent level for specific nozzles).PartDropPart148
section 4operation4.2.3. Cut FlatnessTop And Bottom Rounded. Condition usually occurs whenmaterial is .25" thick (6,4mm) or less.•High current for given material thickness (See ProcessData for proper settings).DropPartTop Edge Undercut•Standoff low (Arc Voltage)DropPart149
Page 2 and 3: Be sure this information reaches th
Page 4 and 5: table of contents134
Page 6 and 7: section 1safety precautionsWARNINGW
Page 8 and 9: section 2DEscription2.4 Optional Ac
Page 10 and 11: section 2DEscriptionPT-36 600A Star
Page 12 and 13: section 2DEscription142
Page 14 and 15: section 3INstallation3.1.2 Connecti
Page 16 and 17: section 4operationWARNINGExplosion
Page 20 and 21: section 4operation4.2.4. Surface Fi
Page 22 and 23: section 4operation4.3 Torch Flow Pa
Page 24 and 25: section 5Maintenance5.2 Torch Front
Page 26 and 27: section 5Maintenance7. Remove elect
Page 28 and 29: section 5Maintenance4. Unscrew nozz
Page 30 and 31: section 5Maintenance5.4 Assembly Of
Page 32 and 33: section 5Maintenance3. Screw electr
Page 34 and 35: section 5Maintenance5.7 Removal and
Page 36 and 37: section 5Maintenance4. To install t
Page 38 and 39: section 5MaintenanceChecking for Co
Page 40 and 41: section 5Problem: Failure to startS
Page 42: section 5Maintenance172

PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

Create successful ePaper yourself

Delete template?

Save as template?