PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

section 5Maintenance5.7 Removal and Replacement of the Torch BodyWARNINGElectric Shock Can Kill!Before performing torch maintenance:• Turn power switch of the power source console to the OFF position• Disconnect primary input power.1. Loosen the worm gear hose clamp so that the torch sleeving can be freed and pulled back up the cablebundle. Approximately 7 inches should be far enough. Loosen the #10-32 setscrews in the end of the sleeveso that the brass handle extension is free to spin as the sleeve is loosened. Unscrew the torch sleeve and slideit back until the pilot arc connection is exposed.HandleTorch Body164