PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

More documents

Recommendations

Info

section 5Maintenance3. Screw electrode assembly in a clockwise direction to torch body. Electrodewill tighten in the correct position when collet closes.Nozzle Retaining Cup<strong>Torch</strong> BodyNozzleNOTE:When assembling, place the nozzle inside the nozzle retaining cup and thread the retainer/nozzle combinationon the torch body. This will help align the nozzle with the assembly. The shield cup and shieldcup retainer should be installed only after installing the nozzle retaining cup and nozzle. Otherwise theparts will not seat properly and leaks may occur.162
section 5Maintenance5.6 <strong>Torch</strong> Body• Inspect O-rings daily and replace if damaged or worn.• Apply a thin coat of silicone grease to O-rings before assembling torch. This facilitates easy future assemblyand disassembly for service.• O-ring (1.61 I.D. X .070 BUNA-70A).WARNINGElectric Shock Can Kill!Before performing torch maintenance:• Turn power switch of the power source console to the OFF position• Disconnect primary input power.O-Ring locations•••Keep electrical contract ring contact points free of grease and dirt.Inspect ring when changing nozzle.Clean with cotton swab dipped in isopropyl alcohol.Contact Ring PointsContact RingContact Ring ScrewContact Ring Points163
Page 2 and 3: Be sure this information reaches th
Page 4 and 5: table of contents134
Page 6 and 7: section 1safety precautionsWARNINGW
Page 8 and 9: section 2DEscription2.4 Optional Ac
Page 10 and 11: section 2DEscriptionPT-36 600A Star
Page 12 and 13: section 2DEscription142
Page 14 and 15: section 3INstallation3.1.2 Connecti
Page 16 and 17: section 4operationWARNINGExplosion
Page 18 and 19: section 4operationcautionBefore att
Page 20 and 21: section 4operation4.2.4. Surface Fi
Page 22 and 23: section 4operation4.3 Torch Flow Pa
Page 24 and 25: section 5Maintenance5.2 Torch Front
Page 26 and 27: section 5Maintenance7. Remove elect
Page 28 and 29: section 5Maintenance4. Unscrew nozz
Page 30 and 31: section 5Maintenance5.4 Assembly Of
Page 34 and 35: section 5Maintenance5.7 Removal and
Page 36 and 37: section 5Maintenance4. To install t
Page 38 and 39: section 5MaintenanceChecking for Co
Page 40 and 41: section 5Problem: Failure to startS
Page 42: section 5Maintenance172

PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?