PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

More documents

Recommendations

Info

section 5Maintenance5.7 Removal and Replacement of the <strong>Torch</strong> BodyWARNINGElectric Shock Can Kill!Before performing torch maintenance:• Turn power switch of the power source console to the OFF position• Disconnect primary input power.1. Loosen the worm gear hose clamp so that the torch sleeving can be freed and pulled back up the cablebundle. Approximately 7 inches should be far enough. Loosen the #10-32 setscrews in the end of the sleeveso that the brass handle extension is free to spin as the sleeve is loosened. Unscrew the torch sleeve and slideit back until the pilot arc connection is exposed.Handle<strong>Torch</strong> Body164
section 5Maintenance2. Unscrew the gas hoses and power cables from the torch head assembly by using a 7/16" (11.1mm) and a 1/2"(12.7mm) wrench. Disconnect the power cables which are threaded onto the shorter stems at the back of thetorch. Note that one of these connections is left-handed.1/2" power cableconnections1/2" shield gasconnection7/16" plasma gasconnection3. Unwrap the electrical tape at the back of the gray plastic insulator over the pilot arc connection. Slide theinsulator back and undo the knife connectors.Wire splicePilot Arc CableElectrical Tape(shown removed)Knife-splice connection165
Page 2 and 3: Be sure this information reaches th
Page 4 and 5: table of contents134
Page 6 and 7: section 1safety precautionsWARNINGW
Page 8 and 9: section 2DEscription2.4 Optional Ac
Page 10 and 11: section 2DEscriptionPT-36 600A Star
Page 12 and 13: section 2DEscription142
Page 14 and 15: section 3INstallation3.1.2 Connecti
Page 16 and 17: section 4operationWARNINGExplosion
Page 18 and 19: section 4operationcautionBefore att
Page 20 and 21: section 4operation4.2.4. Surface Fi
Page 22 and 23: section 4operation4.3 Torch Flow Pa
Page 24 and 25: section 5Maintenance5.2 Torch Front
Page 26 and 27: section 5Maintenance7. Remove elect
Page 28 and 29: section 5Maintenance4. Unscrew nozz
Page 30 and 31: section 5Maintenance5.4 Assembly Of
Page 32 and 33: section 5Maintenance3. Screw electr
Page 36 and 37: section 5Maintenance4. To install t
Page 38 and 39: section 5MaintenanceChecking for Co
Page 40 and 41: section 5Problem: Failure to startS
Page 42: section 5Maintenance172

PT-36 Mechanized Plasmarc Cutting Torch Instruction Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?