IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 5 Configuring the Gateway to Receive Email
OL-25136-01
$BLOCKED
These policies are summarized in Table 5-12.
Figure 5-13 Predefined Mail Flow Policies for a Private Listener
Table 5-13 Predefined Mail Flow Policies for Private Listeners
Policy Name
Primary
Behavior
(Access Rule) Parameters Value
$RELAYED RELAY Maximum messages / session:
Maximum recipients / message:
Maximum message size:
Maximum concurrent connections:
SMTP Banner Code:
SMTP Banner Text:
Override Hostname:
Use TLS:
Use Sophos virus scanning:
Maximum recipients / hour:
Maximum rcpt / hour Error Code:
Max recipients / hour Text:
Use SenderBase:
$BLOCKED
(Used by All)
REJECT Maximum messages / session:
Maximum recipients / message:
Maximum message size:
Maximum concurrent connections:
SMTP Banner Code:
SMTP Banner Text:
Override Hostname:
Use TLS:
Use Sophos virus scanning:
Maximum recipients / hour:
Maximum rcpt / hour Error Code:
Max recipients / hour Text:
Use SenderBase:
Default
Default
Default
Default
Default
Default
Default
Default
Off (if enabled)
-1 (Disabled)
Not applicable
Not applicable
Default
Not applicable
Not applicable
Not applicable
Not applicable
Default
Default
Default
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
$BLOCKED is a named policy, which is the same as the private listener’s default HAT settings. The final
ALL entry in a HAT for a private listener also uses the $BLOCKED policy as the default behavior.
Each private listener, by default, has the following predefined sender group and corresponding mail flow
policy shown in Table 5-14 defined by default:
Table 5-14 Predefined Sender Groups and Mail Flow Policies for Private Listener
This Sender Group: Uses this Mail Flow Policy:
RELAYLIST $RELAYED
ALL $BLOCKED
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
5-29