IronPort - Configuration Guide - AsyncOS 7.6.1

6-34
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
Chapter 6 Email Security Manager
Figure 6-20 Enabling Content Filters for the Policy and Selecting Specific Content Filters
The content filters defined in the master list (which were created in Content Filters Overview,
page 6-6 using the Incoming Content Filters pages) are displayed on this page. When you change
the value to “Enable Content Filters (Customize settings),” the checkboxes for each filter change
from disabled (greyed out) to become enabled.
Step 4 Check the Enable checkbox for each content filter.
Step 5 Click Submit.
The Incoming Mail Policies page is displayed, and the table is updated to show the names of the
filters that have been enabled for the default policy.
Figure 6-21 Three Content Filters Enabled for the Default Incoming Mail Policy
To disable the “no_mp3s” content filters for the “engineering” policy:
Step 1 Click the link for the Content Filters security service (the Content Filters column) in the engineering
team policy row.
Step 2 On the Content Filtering security service page, change the value for Content Filtering for Policy:
Engineering from “Enable Content Filtering (Inherit default policy settings)” to “Enable Content
Filtering (Customize settings).”
Because this policy was using the default values, when you change the value from “Use Default
Settings” to “Yes,” the checkboxes for each filter change from disabled (greyed out) to become
enabled.
Step 3 Deselect the checkbox for the “no_mp3s” filter.
Figure 6-22 Deselecting a Content Filter
Step 4 Click Submit.
The Incoming Mail Policies page is displayed, and the table is updated to show the names of the
filters that have been enabled for the engineering policy.
OL-25136-01