IronPort - Configuration Guide - AsyncOS 7.6.1

RELAYLIST
5-30
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
Chapter 5 Configuring the Gateway to Receive Email
This basic sender group and mail flow policy enables a framework for you to begin classifying the email
flowing out of your gateway on a private listener.
Add senders you know should be allowed to relay to the Relaylist sender group. The $RELAYED mail
flow policy is configured so that email from senders you are allowing to relay has no rate limiting, and
the content from those senders is not scanned by the anti-spam scanning engine or anti-virus software.
Note The systems you allowed to relay email through the Cisco IronPort appliance when you created an
outbound (private) listener in the GUI System Setup wizard (or CLI systemsetup command) are
automatically added to the RELAYLIST sender group. See Step 3: Network, page 3-17.
Note By default, C10/100 customers are prompted to create only one public listener during the systemsetup
command. Public listeners created on Cisco IronPort C10/100 appliances also include a $RELAYED
mail flow policy that is used to relay mail for internal systems.
Managing Sender Groups and Mail Flow Policies via the GUI
The Mail Policies > HAT Overview and Mail Flow Policy pages allow you to configure a HAT settings
for a listener. From these pages, you can:
See the mapping of sender groups to mail flow policies.
Create, edit, or delete sender groups.
Create, edit, or delete mail flow policies.
Re-order HAT entries for a listener.
Click the Mail Policies > HAT Overview link. See Figure 5-14. Choose the listener you want to configure
from the Listener: drop-down list.
Figure 5-14 Host Access Table Overview Page
From the HAT Overview page, you can add a sender group and edit the mail flow policies for a listener.
OL-25136-01