IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 3 Setup and Installation
Proceeding to the Next Steps
OL-25136-01
After you successfully configure your appliance to work with your Active Directory Wizard, or skip the
process, the System Setup Next Steps page appears.
Figure 3-14 System Setup is Complete
Click the links on the System Setup Next Steps page to proceed with the configuration of your Cisco
IronPort appliances.
Accessing the Command Line Interface (CLI)
Access to the CLI varies depending on the management connection method you chose in Connecting to
the Appliance, page 3-9. The factory default username and password are listed next. Initially, only the
admin user account has access to the CLI. You can add other users with differing levels of permission
after you have accessed the command line interface for the first time via the admin account. (For
information about adding users, see “Common Administrative Tasks” in the Cisco IronPort AsyncOS for
Email Daily Management Guide.) The System Setup Wizard asks you to change the password for the
admin account. The password for the admin account can also be reset directly at any time using the
password command.
To connect via Ethernet: Start an SSH or Telnet session with the factory default IP address
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username
and password below.
To connect via a Serial connection: Start a terminal session with the communication port on your
personal computer that the serial cable is connected to. Use the settings for serial port outlined in
Connecting to the Appliance, page 3-9. Enter the username and password below.
Log in to the appliance by entering the username and password below.
Factory Default Username and Password
Username: admin
Password: ironport
For example:
login: admin
password: ironport
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
3-25