IronPort - Configuration Guide - AsyncOS 7.6.1

15-20
Figure 15-9 The Alerts Page
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
Chapter 15 System Administration
Note If you enabled AutoSupport during System Setup, the email address you specified will receive alerts for
all severities and classes by default. You can change this configuration at any time.
Adding New Alert Recipients
The Alerts page lists the existing alert recipients and alert settings.
From the Alerts page, you can:
Add, configure, or delete alert recipients
Modify the alert settings
Step 1 Click Add Recipient on the Alerts page. The Add Alert Recipients page is displayed:
Figure 15-10 Adding a New Alert Recipient
Step 2 Enter the recipient’s email address. You can enter multiple addresses, separated by commas.
Step 3 Select which alert severities to receive.
Step 4 Submit and commit your changes.
Configuring Existing Alert Recipients
Step 1 Click the alert recipient in the Alert Recipients listing. The Configure Alert Recipient page is displayed.
Step 2 Make changes to the alert recipient.
Step 3 Submit and commit your changes.
OL-25136-01