IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 5 Configuring the Gateway to Receive Email
OL-25136-01
Step 3 Enter the recipient address (see Defining Recipients, page 5-51 for more information about valid
entries).
Step 4 Choose to accept or reject the recipient.
Step 5 Optionally, you can choose to bypass LDAP acceptance queries for the recipient (See Bypassing LDAP
Accept for Special Recipients, page 5-52).
Step 6 If you want to use a custom SMTP response for this entry, select Yes for Custom SMTP Response. Enter
a response code and text.
Step 7 Optionally, you can choose to bypass throttling (see Bypassing Throttling for Special Recipients,
page 5-52) select Yes for Bypass Receiving Control.
Step 8 Submit and commit your changes.
Deleting RAT Entries
Step 1 Mark the checkbox in the Delete column for each entry you want to delete.
Step 2 Click Delete.
Step 3 The entry or entries you marked are removed from the RAT.
Step 4 Commit your changes.
Modifying RAT Entries
Step 1 Click the RAT entry in the Recipient Access Table Overview. The Edit Recipient Access Table page is
displayed.
Step 2 Make changed to the entry.
Step 3 Commit your changes.
Changing the Order of RAT Entries
Step 1 Click Edit Order The Edit Recipient Access Table Order page is displayed:
Figure 5-40 Changing the Order of RAT Entries
Step 2 Change the order by arranging the values in the Order column.
Step 3 Commit your changes.
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
5-55