IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 15 System Administration
OL-25136-01
Table 15-8 Listing of Possible System Alerts (Continued)
Alert Name Message and Description Parameters
MAIL.RES_CON_START_
ALERT.QUEUE_SLOW
MAIL.RES_CON_START_
ALERT.QUEUE
MAIL.RES_CON_START_
ALERT.WORKQ
MAIL.RES_CON_START_
ALERT
This system (hostname: $hostname)
has entered a ‘resource conservation’
mode in order to prevent the rapid
depletion of critical system resources.
The queue is overloaded and is unable
to maintain the current throughput.
Critical. Sent when the mail queue is
overloaded and system resource
conservation is enabled.
This system (hostname: $hostname)
has entered a ‘resource conservation’
mode in order to prevent the rapid
depletion of critical system resources.
Queue utilization for this system has
exceeded the resource conservation
threshold of $queue_threshold_start%.
The allowed receiving rate for this
system will be gradually decreased as
queue utilization approaches
$queue_threshold_halt%.
Critical. Sent when queue utilization
has exceeded the system resource
conservation threshold.
This system (hostname: $hostname)
has entered a ‘resource conservation’
mode in order to prevent the rapid
depletion of critical system resources.
Listeners have been suspended
because the current work queue size
has exceeded the threshold of
$suspend_threshold. Listeners will be
resumed once the work queue size has
dropped to $resume_threshold. These
thresholds may be altered via use of the
‘tarpit’ command on the system CLI.
Information. Sent when listeners are
suspended because the work queue size
is too big.
This system (hostname: $hostname)
has entered a ‘resource conservation’
mode in order to prevent the rapid
depletion of critical system resources.
Critical. Sent when the appliance
enters “resource conservation” mode.
’hostname’ - The name of
the host.
‘hostname’ - The name of
the host.
‘queue_threshold_start’ -
The percent threshold where
queue tarpitting starts.
‘queue_threshold_halt’ -
The percent threshold where
the system will halt due to
the queue being too full.
‘hostname’ - The name of
the host.
‘suspend_threshold’ - Work
queue size above which
listeners are suspended.
‘resume_threshold’ - Work
queue size below which
listeners are resumed.
‘hostname’ - The name of
the host.
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
15-29