IronPort - Configuration Guide - AsyncOS 7.6.1

Chapter 3 Setup and Installation
Step 1: Start
Step 2: System
Setting the Hostname
Configuring System Alerts
Configuring Report Delivery
OL-25136-01
Step through the System Setup Wizard, clicking Next after you complete each step. You can move back
to a previous step by clicking Previous. At the end of the process, you are prompted to commit the
changes you have made. Your changes will not take effect until they have been committed. If you click
Next, but have left a required field blank (or entered incorrect information), the fields in question are
outlined in red. Make your corrections and click Next again.
Begin by reading the license agreement. Once you have read and agreed to the license agreement, check
the box indicating that you agree and then click Begin Setup to proceed.
Figure 3-5 System Setup Wizard: Step 1. Start
You can also view the text of the agreement here:
https://support.ironport.com/license/eula.html
Define the fully-qualified hostname for the Cisco IronPort appliance. This name should be assigned by
your network administrator.
Cisco IronPort AsyncOS sends alert messages via email if there is a system error that requires the user’s
intervention. Enter the email address (or addresses) to which to send those alerts.
You must add at least one email address that receives System Alerts. Enter a single email address, or
separate multiple addresses with commas. The email recipients initially receive all types of alerts at all
levels, except for Directory Harvest Attack Prevention alerts. You can add more granularity to the alert
configuration later. For more information, see Alerts, page 15-15.
Enter the address to which to send the default scheduled reports. If you leave this value blank, the
scheduled reports are still run. They will be archived on the appliance rather than delivered.
Cisco IronPort AsyncOS 7.6 for Email Configuration Guide
3-15